Trim & Tire Coating Kit

1. 1. CLEAN SURFACES

   Rinse tires and trim to remove loose dirt and debris. Apply Foaming Tire Cleanser liberally to tire sidewalls and exterior plastic and rubber trim. Agitate as needed with the included tire scrub brush to remove contamination, then rinse thoroughly. Continue scrubbing until foam is bright white, indicating a fully clean surface. For heavier tire contamination, additional rinsing and scrubbing steps may be required before foam will turn white. Once foam is white, repeat this process across all tires and trim.

2. 2. PREP FOR COATING

   Ensure all surfaces are completely dry before applying coatings. Proper surface preparation is critical—any remaining moisture or contamination may affect bonding and performance.

3. 3. APPLY TIRE COATING

   Apply Tire Coating Pro to the Tire Conditioner Applicator. Spread evenly across the tire sidewall, working the product into the rubber. Allow the coating to absorb fully before moving the vehicle.

4. 4. APPLY TRIM COATING

   Apply Trim Coating Pro to the 5" Coating Applicator or a microfiber towel. Spread evenly across plastic and rubber trim surfaces. After waiting a few seconds, re-wipe trim to level the coating and remove any excess for complete coverage and a consistent, uniform appearance.

5. 5. BUILD IF NEEDED

   For deeper color or additional protection, apply additional layers after the first layer has absorbed. Multiple layers can enhance appearance, especially on heavily faded surfaces.

6. 6. FINAL WIPE

   Inspect all treated areas and wipe away any excess product using a clean microfiber towel to ensure full coverage and no high spots.

7. 7. ALLOW TO CURE

   Allow coatings to cure before exposing surfaces to water or driving. Avoid contact with moisture during the initial curing period.

IMPORTANT INFORMATION

Do not apply to hot surfaces or in direct sunlight.
Do not allow products to freeze during storage.
Ensure surfaces are fully clean before applying coatings to maximize bonding and durability.
Allow coatings to cure before exposing to water or driving the vehicle.
Use only on exterior rubber and plastic surfaces such as tire sidewalls and trim.

APPLICATION TIPS

For best results, thoroughly clean tires until foam turns bright white before applying coatings.
Apply coatings in thin, even layers to avoid streaking or uneven finish.
For heavily faded surfaces, multiple layers can improve depth and overall appearance.
Use separate applicators for tires and trim to maintain a consistent finish.