Matte Body Wash

TWO BUCKET HAND WASH Instructions

1. 1. Prep Bucket

   Place wash pads on top of Grit Guard at the bottom of an empty 5-gallon wash bucket.

2. 2. Add Soap

   Pour 1 oz (2 capfuls) of Matte Body Wash on top of your wash pads.

3. 3. Add Water

   Add 3-4 gallons of water to the bucket.

4. 4. Create Foam

   Agitate water and soap with wash pads to create foam.

5. 5. Initial Rinse

   Rinse vehicle before spreading foam to remove any loose contaminants.

6. 6. Spread Foam on Car

   Pull wash pads out and spread foam over your vehicle's body.

7. 7. Agitate foam

   Agitate foam lightly with wash pads, going from the top down. For vehicles with only light contamination, agitation may not be necessary.

8. 8. Rinse & Dry

   When complete, rinse the surface and dry with a waffle weave microfiber towel.

Foam Cannon Instructions

Requires pressure washer

• Soap Amount: 1-2 oz of Matte Body Wash Body Wash + 16–32 oz of warm water for better mixing
• Foam Thickness Dial: Adjust for more or less suds
• Spray Pattern: Wide for coverage, narrow for tough spots
• Pressure Washer Specs: 1.5–2.5 GPM, 800–1200 PSI

1. 1. Pre-Rinse Vehicle

   Rinse vehicle thoroughly with water to remove loose contamination.

2. 2. Foam and let dwell 2-4 minutes

   Spray vehicle with foam from top to bottom and let dwell for 2-4 minutes. Do not let dry.

3. 3. Agitate with wash mitt

   Using a soft, clean wash mitt, agitate the foam gently to remove contamination.

4. 4. Rinse

   After agitating, rinse the foam away as thoroughly as possible.

5. 5. Dry

   Dry the vehicle using a soft, clean microfiber towel (preferably flat weave) or an air blower.

Foam Gun Instructions

Requires garden hose

• Soap Amount: 2–4 oz of Matte Body Wash + fill with warm water for better mixing
• Foam Thickness Dial: Adjust for desired foam thickness
• Dilution Dial: Adjust for desired foam thickness
• Spray Pattern: Wide for coverage, narrow for deep cleaning

1. 1. Pre-Rinse Vehicle

   Rinse vehicle thoroughly with water to remove loose contamination.

2. 2. Foam and let dwell 2-4 minutes

   Spray vehicle with foam from top to bottom and let dwell for 2-4 minutes. Do not let dry.

3. 3. Agitate with wash mitt

   Using a soft, clean wash mitt, agitate the foam gently to remove contamination.

4. 4. Rinse

   After agitating, rinse the foam away as thoroughly as possible.

5. 5. Dry

   Dry the vehicle using a soft, clean microfiber towel (preferably flat weave) or an air blower.

Safe for ceramic coated matte vehicles.
Avoid washing in direct sunlight.
Rinse foam cannon/gun after use to prevent clogging. Do not pour product into an empty bucket.
Do not pour product into an empty fluid tank.
If using a foam gun, fill the fluid tank with water before pouring in 1 oz of Matte Body Wash.
Before applying, test a small amount in an inconspicuous place to check compatibility with the surface.