Matte Paint Prescription

MATTE BODY WASH



1. 1. Preparation

   Start with an empty bucket. Mix 2 generous capfuls
   of Matte Body Wash per gallon of water.

2. 2. Creating suds

   Add water to the bucket and agitate using a wash
   pad to generate a rich lather.

3. 3. INITIAL RINSE

   Before applying the soap, thoroughly rinse the
   vehicle to remove loose dirt and debris.

4. 
   
   4. WASHING TECHNIQUE

   Begin at the top and work downwards,
   washing the car section by section.
   Regularly rinse wash pads to eliminate accumulated dirt.

5. 5. FINAL RINSE

   After washing, rinse the car
   until all soap residue and suds are completely gone.

6. 6. DRYING PROCESS

   Gently dry the vehicle with soft, clean microfiber towels.
   If planning to apply Matte Paint Coating afterwards,
   skip the drying step.

For optimal finish maintenance, wash the car at least twice a month.
Before full application, test a small amount on an inconspicuous area to ensure surface compatibility.

MATTE PAINT CLEANSER



1. 1. Mist

   Out of direct sunlight, spray on to contaminated area.

2. 2. WIPE OFF

   Let sit for 10-15 seconds, then wipe down with a clean microfiber towel.

3. 
   
   
   3.REAPPLY

   If contamination remains, additional applications/more dwell time may be necessary. Do not allow product to dry.

Do not allow product to dry on surface.
Do not allow product to freeze.
Do not apply in direct sunlight.
Before applying, test a small amount in an inconspicuous place to check compatibility with surface.
Do not scrub or use unnecessary pressure when wiping down.
Product can remove some nanocoatings. If applied to a surface coated with Matte Paint Coating, rinse and reapply coating after use.
Use only as a spot cleaner. For decontaminating matte paint, try Matte Decon.

MATTE PAINT COATING



1. 1. PREPARATION

   Ensure surface is clean. Use Matte Body Wash to remove loose contaminants and Matte Paint Cleanser to spot clean more stubborn messes. For optimal bonding, decontaminate with Matte Decon prior to application.

2. 2. WET THE SURFACE

   Mist water onto a panel. For optimal bonding, use distilled water.

3. 3. BOTTLE PREP

   Lightly shake the Matte Paint Coating bottle.

4. 
   
   
   4. APPLICATION

   Place 10 to 15 drops onto applicator. Then apply to wet panel in circular or straight back-and-forth motions, being sure to get full coverage.

5. 5. WIPE AWAY

   Immediately wipe panel down completely with a fresh microfiber towel.

6. 6. REPEAT

   Repeat steps 2-6 until entire vehicle is covered, applying 5-6 more drops with each panel.

Do not apply in direct sunlight.
Avoid washing vehicle or getting it wet for one week after application.
Always test a small amount on an inconspicuous area to ensure surface compatibility.

MATTE FINAL FINISH



1. 1. Mist

   Spray the lightly spoiled area with Matte Final Finish.
   of Matte Body Wash per gallon of water.

2. 
   
   
   2. Clean

   Wipe gently with a microfiber cloth in long horizontal strokes to remove the product.

3. 3. Repeat

   Repeat steps 1-2 if necessary.

For use only on light contamination. For more stubborn messes, try Matte Paint Cleanser.
For best results, use on fresh contaminants. Older messes may be more difficult to remove.
Always test in an inconspicuous area first to check for surface compatibility.