Nano-Resin Kit

1. 1. INSPECT PAINTWORK

   Inspect paintwork for defects. Decontaminate as needed with Total Decon and a Clay product. Remove scratches and defects as desired using the appropriate grade(s) of Nano Surface Primer(s).

2. 2. CLEAN SURFACE

   Wipe away any remaining NSP residue with a microfiber towel. If you did not use NSPs and instead used polish, you must use Panel Prime to cleanse the surface of polishing oils; otherwise, the coating will not bond.

3. 3. SPRAY PAINT COATING BUILDER

   Spray Paint Coating Builder onto a microfiber towel. Spread the Paint Coating Builder in vertical overlapping lines down the panel, followed by horizontal overlapping lines.

4. 4. LET SIT

   Let sit 2-3 minutes, then remove with a microfiber towel. Repeat steps 3-4 until all desired paint surfaces are coated.

5. 5. PREP COATING APPLICATOR

   Apply a line of Nano-Resin down the center of the coating applicator.

6. 6. APPLY NANO-RESIN

   Start by applying Nano-Resin in vertical lines down the panel. After you've covered your panel with vertical lines, go back and repeat with horizontal lines. This crosshatching will ensure full coverage. Avoid getting the product in panel gaps.

7. 7. LET SIT

   Let the product sit on the surface until a shimmering "oil slick" effect is observed. Wipe panel with a clean, dry, microfiber towel.

8. 8. REPEAT

   Repeat steps 5-6 on each panel until your entire vehicle is protected. Reapply several drops of Nano-Resin to your applicator every few panels or as needed.

9. 9. LET CURE

   Allow coating to cure undisturbed for one hour. After one hour you may follow with additional layers.

10. 10. CURE TIME

    If you are in a high humidity environment, keep coating dry for 24 hours after application. In more arid environments, allow keep dry for 48 hours

For best results, spray the panel or small area with distilled water prior to applying the coating.
Do not apply Nano-Resin in direct sunlight.
Do not allow this product to freeze during storage.
If applied in temperatures less than 65-70 degrees the vehicle may need more flash time. In warmer, more arid climates Nano-Resin will need less flash time.
Inspect the vehicle in natural light for a better view of high spots.
Keep vehicle completely dry between applications and for at least 1 hour after final application. After 1 hour the vehicle can be exposed to light rain without affecting the bonding process.
Full cure will take 24-48 hours. After fully cured the surface will be noticeably glossier and the coating will be at full hardness.
Leaving the vehicle in the sun or under infrared lamps after application will shorten the amount of time needed for Nano-Resin to bond to the paint surface.
Avoid washing the vehicle with soap for 7 days after application. After this follow our prescribed maintenance regimen.
Keep bottle closed when not in use.
Apply AdvanceCoat: Gloss once every 3-4 months or as needed to restore hydrophobicity and gloss.