Nano-Resin MX Kit

1. 1. INSPECT PAINTWORK

   Inspect paintwork for defects. Decontaminate as needed with Total Decon and a Clay product. Remove scratches and defects as desired using the appropriate grade(s) of Nano Surface Primer(s).

2. 2. CLEAN SURFACE

   Wipe away any remaining NSP residue with a microfiber towel. If you did not use NSPs and instead used polish, you must use Panel Prime to cleanse the surface of polishing oils; otherwise, the coating will not bond.

3. 3. APPLY PAINT COATING BUILDER

   Spray Paint Coating Builder onto a microfiber towel. Spread the Paint Coating Builder in vertical overlapping lines down the panel, followed by horizontal overlapping lines.

4. 4. LET SIT

   Let sit 2-3 minutes, then remove with a microfiber towel. Repeat steps 3-4 until all desired paint surfaces are coated.

5. 5. PREP COATING APPLICATOR

   Use the included pipette to prime the coating applicator with 5-6 drips down the center and one drop at each corner.

6. 6. APPLY NANO-RESIN MX

   Start by applying Nano-Resin MX in vertical lines down the panel. After you've covered your panel with vertical lines, go back and repeat with horizontal lines. This crosshatching will ensure full coverage. Avoid getting the product in panel gaps.

7. 7. LET SIT

   Let the product sit on the surface for 30 seconds to a minute. Wipe the panel with a clean, dry microfiber towel.

8. 8. REPEAT

   Repeat steps 5-6 on each panel until your entire vehicle is protected. Reapply 4-5 drops of Nano-Resin Pro to your applicator for each panel.

9. 9. LET CURE

   Allow the coating to cure undisturbed for one hour. After, if product is left over, re-apply to high impact areas.

For best results, spray the panel or small area with distilled water prior to applying the coating.
Do NOT apply Nano-Resin MX in direct sunlight. Do not allow this product to freeze during storage.
If applied in temperatures less than 65-70° the product may need more time on the surface before removal. In warmer, more arid climates Nano-Resin MX may need less time.
Inspect the vehicle in natural light for a better view of high spots.
Keep vehicle completely dry between applications and for at least 1 hour after final application. After 1 hour the vehicle can be exposed to light rain without affecting the bonding process.
Coating will cure after 24-48 hours, after which it is fully bonded to the paintwork.
Avoid washing the vehicle with soap for 7 days after application. After this, follow our prescribed maintenance regimen, including the use of AdvanceCoat: Gloss as a coating reinforcer.
Use entire bottle when applying. Do not re-cap opened bottle for future applications.